Description
OEM LuK dual-mass clutch and flywheel kit for VW vehicles with a TSI engine and 6-speed manual transmission. This kit comes with a pressure plate and flywheel bolts as well. Make sure you bleed the slave cylinder BEFORE installing to get all the air bubbles out!
Includes the Following:
OEM LuK DMF – DMF131 / 06J105266H
OEM LuK Clutch, Pressure Plate & Throw-out Bearing/Slave Cylinder Kit – 02-056 / 06J141015J
6x Pressure Plate Bolts – N90320701
8x Flywheel Bolts – N90665001
Fits the Following with 2.0T engines and 6 speed manual:
2008-2013 Audi A3/A3 Quattro
2012-2013 VW Beetle
2009-2016 VW CC
2009-2012 VW Eos
2008-2014 VW GTI
2008-2010, 2012-2013 VW Jetta
2008 VW Passat
2009-2010 VW Passat CC
2009-2016 VW Tiguan
Installation Note: Make sure you bleed the slave cylinder BEFORE installing it to get all the air bubbles out! It’s a bench-bleed sort of thing, this makes sure that the slave will start with some fluid in it and the most difficult to remove air pockets already pushed out. You do still do the normal bleed procedure as well once everything is bolted into the car, but doing the bench-bleed before bolting the slave in makes it considerably easier to do the final bleed once everything is assembled.
You can compress the throwout bearing with one hand, with the 90 degree neck pointing up, pour a little brake fluid into it, then release the T.O. bearing. This will pull the fluid in. Tip it upright as it would normally sit in the transmission and slowly compress the throw out bearing again, tip it so you can fill some more easily, repeat a few times until it seems like you’ve got as much fluid into it as you can, then go ahead and bolt it into the transmission.
