Camshaft Kit, BRM

Description

Camshaft kit for VW TDIs with a BRM engine code. This kit includes everything that should be replaced when the camshaft is replaced.

Includes the Following:
Eurospec BRM Camshaft — 038109101AH
8x Camshaft Followers (Nitride Coated) — 038109309C
Camshaft Bearing Set — 038198673C
10x Journal Cap Bolts — 038103714 (Non-stretch; Torque to 144 lb/in)
8x Injector Rocker Bolt — 038103714A (Non-stretch; Torque to 25 lb/ft)
Vacuum Pump Gasket — 038145215
Joe Gibbs Assembly Lube Packet

Fits the Following:
2005.5-2006 VW Jetta TDI

Installation Note: Proper break-in of a camshaft is essential for proper functioning and longevity. Joe Gibbs Break-in oil facilitates that well. Below is the recommended process.
1. Put assembly lube on all lobes, lifter faces, distributor gears, bearing journals, lifter barrels, and oil pump gears.
2. Turn the engine over by hand to make sure that nothing is binding up (e.g. cam bearings are properly seated) and that timing is correct.
3. Rev engine to 2000-3000 RPM for 20-30 minutes. Drain break-in oil, keep filter in place.
4. Refill with break-in oil and drive normally for about 500 miles.
5. Drain oil again and replace the filter and oil using proper VW 505.01 spec oil, such as Pentosin HPII or Liquimoly. A bottle of ZDDP additive can provide further protection.

Note on Torsion: Use only the following torque spec.
Journal cap bolts – 038 103 714 — Special Non-stretch torque to 60, 120, 144 inch/lb – Strike caps between each torque & be VERY Careful!
Injector rocker bolts – 038 103 714 A — Special Non-stretch torque to 25 lb/ft